Description

Ocean 3d PU Wall Panel, by Decoflair

New range in a limited stock.

Price is for 2 panels.

Size 760 x 380 x 13 mm

Easy DIY installation and paintable.

Tough and durable, high quality, cast PU hard foam construction.

Installation instructions included.

Recommended installation: solvent based cartridge glue and M3 Double sided sticky tabs.

Indoor use only.

Key Points

• Design: OCEAN by Decoflair
• Size: 760 x 380 x 13 mm
• Weight: 0.5kg /pc
• Handy size & lightweight.
• Polyurethane: a familiar, easy material to use.
• Finish: White sprayed matt acrylic primer, smooth face.
• Easy, quick and fast to install.
• Paint with any quality wall paint.
• Good sound proofing quality.
• Heat insulation properties.

Installation Guide

MATERIALS REQUIRED  Sandpaper grit 150 or finer, Brush / sponge, Spirit level, Ruler and pencil, Nail clamps or nails; wood strip if necessary, Hammer, Liquid nails type glue, M3 double sided sticky tabs, Cartridge applicator, Spacers (e.g. 1-2mm tile crosses) ,Battery screwdriver, Spatulas, Circular saw with guide rail, Protective goggles, HDPS/PU saw, Finish paint, Painting tools.

WALL PANELS must be stored flat in a dry place.

The recommended temperature is +15 °C to +25°C with a relative humidity of 45% to 65%.

To achieve optimum results, the products should be fitted under similar moisture and temperature conditions as present after the installation (indoor environment). Fitting on a wet backing surface (fresh plaster) and in forced drying conditions (heat gun, dehumidifier, exceptionally high temperature) are to be ruled out.

Check panels and substrates for suitability. The following backing surfaces are suitable: indoor plastered or papered surfaces, coated plaster. Surfaces must be clean, dry, free from dust, degreased and flat; rough down if necessary.